Microwave Oven Universal Mica Wave Guide Cover Sheet 300mm x 300mm, Cut To Size

Fat and food splashes that gather on the cover over time cause the cover to overheat, burn and become soft. This can lead to sparking around the wave guide cover during the microwave cooking cycle. If this is not dealt with it can lead to the cavity being burnt as well. It is important to regularly inspect your wave guide cover for burn marks and replace as necessary.

The sheet supplied is 300mm x 300mm which is a very large sheet and is ideal for replacing the large covers used in some commercial oven roof liners. The sheet is also suitable if you plan to make a lot of wave guide covers. Some commercial ovens do have quite large roof liners made from mica and this cover will fit in many instances. Just check your dimensions before ordering.

This size of sheet should allow you to make around 8 -12 covers for most average ovens. The idea is that you cut and trim this sheet to the size of your original cover. The material is easy to cut with a sharp knife or scissors. No special tools are required. If your old cover has a screw hole in it then a leather punch can be useful to make the hole. Otherwise the point of a screwdriver can be used to make the hole.

Purchasing a universal sheet like this is often the easiest option to obtaining an original cover as the originals can be expensive and in some cases difficult to source especially with all the strange brand names sold by supermarkets etc.

The specification of the sheet is as follows:

• Wave guide cover dimensions: 300mm x 300mm
• Wave guide cover thickness: 0.4mm
• Wave guide material: Mica